Citizen-systems iDP-460 Bedienungsanleitung PDF herunterladen (Seite 9)

iDP-460 User’s Manual

9 CITIZEN

PRECAUTIONS FOR INSTALLATION

• Do not use or store the equipment in a place exposed to fire, moisture, or direct sunlight, or

in a place near a heater or a thermal device where the prescribed operating temperature

and humidity are not met, or in a place exposed to much oil, iron powder, or dust. The

equipment may become out of order, emit smoke, or catch fire.

• Do not install the equipment in a place like a laboratory where chemical reactions are

expected, or in a place where salt or gases are contained in the air. There is a danger of

fire or electric shock.

• Do not put any object on the printer. It may cause trouble.

• Do not use the equipment near a radio or TV receiver. Do not share the power from a plug

socket a radio or TV receiver is connected to. It may cause a reception problem.

• Use the equipment only at the specified voltage and frequency. Otherwise, it may emit

smoke and catch fire or cause other problems.

• Confirm that a plug socket used for connection has sufficient capacity.

• Do not overload a single electrical outlet in connecting the power cable. It may result in

the cable catching fire or a power outage. Also, do not stamp or put any object on the

cable.

• Never connect a grounding cable to a gas pipe. There is a danger of explosion. When

connecting or disconnecting the grounding cable, be sure to disconnect the power plug from

the plug socket.

• When connecting/disconnecting the cables, be sure to turn off the power first, including the

connected side, and then connect/disconnect them, holding a plug and a connector. Do not

pull or carry the equipment with a load applied to the cable.

• Connect a connector cable securely. If a reverse-polarity connection is made, internal

elements may be broken or a mating device may be adversely affected.

• Use a shielding wire or twisted pair wire for a signal line, in order to minimize noise effect.

Avoid connecting to a device that is likely to generate noise.

• When a drawer kick connector is provided, do not connect any device other than the

prescribed solenoid specifications. Negligence of this could cause trouble.

• Use the equipment in an environment where there is a plug socket near the main body and

you can easily disconnect the power plug from it, to shut off the power.

• When the equipment will not be used for a long period of time, unplug it.

• When transporting the equipment, remove the rolled paper from it.

• Install the equipment on a flat, stable desk in a well-ventilated place free from vibrations.

(Do not block the ventilation port.)

1 2 3 4 5 6 7 8 9 10 11 12 13 14 ... 77 78

Keine Kommentare

Citizen-systems iDP-460 Bedienungsanleitung Seite 9